Programming for the FAAC gate remote control direct to the FAAC receiver.
1. Press the button (for the channel you wish to program on the receiver) for 1 second then release.
2. The relevant LED on the receiver will flash slowly for 5 secs.3. Within 5 seconds, press the appropriate button on the new FAAC XT44RC remote control for 3 seconds.4. The LED on the receiver will light up steady for 1 second, indicating memory storage completed, and then resumes flashing for another 5 seconds, during which period another radio control can be stored.5. When 5 seconds have elapsed, the LED goes OFF - indicating the end of programming procedure.6. To store other radio remote controls, repeat the above procedure.
The FAAC receiver supports remote learning, you do not need to open receiver box.
You will need a FAAC remote control already programmed.
1. Take an already stored FAAC radio remote control.2. Press and simultaneously hold buttons P1 and P2 on original remote control until LED on receiver board lights up.3. The LED will flash slowly for 5 secs.4. Within 5 seconds, press the button of original already programmed remote control to enable learning on the selected channel.5. The LED on the board relating to the channel being learned flashes for 5 seconds, within which time the code of your new FAAC remote control must be transmitted.6. The LED lights up on steady for 2 seconds, indicating memory storage completed, and then resumes flashing for 5 seconds, during which you can program another radio remote control.7. When 5 seconds have passed, the LED will go OFF - indicating the end of programming procedure.
For all your FAAC remote needs go to :- http://www.retro-remotes.com/faac-remotes